You must be aware that a lot of things happens in the agricultural field and some of them are odd ones. It has often been seen that farmers adjust the ground speed of the concaves so that they can be able to optimize the operations like threshing and separation. But somehow the combine gets slow down only. Some specialists believe that John Deere Concaves respond well to all the complains that most farmers have when it comes to optimization of the machinery for ground speed. A lot of machinery have cruise and auto-pilot setting which when gets activated optimize the ground speed and maximizes the yield with a minimal grain loss.
When it comes to harvesting the terms of acres on per hour basis, all farmers do is think about the time required and seeing the prices of grains, it could be more profitable for the farmers that they should go slow and necessary settings must be done. With few adjustments in John Deere Concaves, the grain loss can be minimized per acre and bushels get maximized.
Optimizing Critical Combine Settings for High Performance
A lot of people have accepted that John Deere Concaves setting works at a ground speed and it helps in balancing out the disruption which might occur when the required settings are not followed, and this is mandatory to follow. For higher performance, the combine settings must get optimized which can be the key to maximize the yield and minimize the loss. You must understand how your machinery works and send the response when taken to the field.
Marketing specialists have suggested that there is no aspect of the individual component to work stand alone but it takes the whole system. The performance of John Deere Concaves depends relatively on how the material is cut and fed to the machine by the header. This dependency also revolves around how the feeder feeds ties to ground speed and it is related to the revolution per-minute for the engine. The speed of sieve shakes gets influenced and it becomes difficult to change the one setting without taking consideration of other settings.
Analyzation of Performance
It is rightly stated that smooth feeding has been the key for performance and after a deep analyzation, it has been confirmed that concave settings and rotor should not be blamed. If the header is set wrong in the case of John Deere Concaves then there is no fault in the cleaning fan setting. It is that place where trash gets collected in the tank or somewhere of the sieve. The components of threshing and separation get overloaded when the slug feeding occurs but only for a temporary basis. It starts producing the bursts of trash in the grain tank. Due to this, damage and potential loss of grain increase when the slug material gets dense.
A cure to this lies in the adjustment of the header and in the case of John Deere Concaves, some prior setting is required which affects the crop harvesting and combine performance greatly.